Pompa Centrifugal Pedrollo CPM 25/160A


Range Of Performance

Flow rate up to 250 l/min (15 m3/h)
Head up to 57 m

Limits Of Use

Manometric suction lift up to 7 m

Liquid temperature up to +90°C
Environmental temperature up to +40°C

Installation and Use

They are recommended for pumping clean water and liquids that are chemically non aggresive to the materials from which the pump is made.
The Pumps in this series are made to standards EN 733 – DIN 24255 and are specifically used in the civil, industrial or agricultural sectors where their characteristics of sturdiness and reliability can best appreciated.
The pumps must be installed in enclosed places, or at least protected against inclement weather.

Construction Characteristics

Pump Body : cast iron, made to standards EN 733 – DIN 24255 and UNI 7467-NF E-44-111, with threaded ports ISO 228/1.
Impeller : brass, of the type with centrifugal radial flow
Motor Shaft ; stainless steel EN 10088-3 – 1.4104
Mechanical Seal : ceramic – graphite – NBR
Electric motor : the pumps are close-coupled to a carefully matched PEDROLLO electric motor, quiet running, totally enclosed fan cooled (TEFC), suitable for continous duty.
CPm : single-phase 230 V – 50 Hz with capacitor and thermal overload protector up to 1.5 kW
CP : three-phase 230/400 V – 50 Hz
Insulation : Class F
Protection : IP 44

Have any Question or Comment?

Leave a Reply

Your email address will not be published. Required fields are marked *

Copy Protected by Chetan's WP-Copyprotect.