Hot Water Meter Sensus 6 Inch WP-Dynamic

Main Characteristics :

Patended hydrodynamically balanced rotor

Patended symmetrical calibration adjustment

Hemetically sealed register  (IP 68)

Register may be rotated through 360°

High overload capability

Removable measuring element

Up to 3 pulsers  ( 1 x OD, 2 x RD) may be fited without breaking the approval seal

Powder coating affords maximum corrosion protection


Application :

Flow sensor for heat meters for commercial and light industrial use DN 50 bis 150 for customer billing

For measurement of hot process water up to 130°C

For high permanent flow rate such us as generaed by pumps, as well as for the measurement of low flow rates in off-peaks periods

Installation in horizontal and vertical pipe lines.


Performance Data WP-Dynamic 130 °C

Nominal Diameter : DN 150

(Qmax) Max. Peak Flow once in life time 24 h Qmax or 5 Min. 1,2 x Q max: 300 m³/h

(Qn) Continuous Flow (±2%) : 150 m³/h

(Qt) Transitional flow (±2%) : 12 m³/h

(Qmin) Minimum Flow : (±2%) : 4.5 m³/h

(Qmin) Starting flow : 1.7 m³/h


Performance data table according to PTB-A22 

Nominal Diameter : DN 150

maximum peak flow short time : 300 m³/h

continuous flow : 150 m³/h

transitional flow : 22.5 m³/h

minimum flow : 6.0 m³/h

Have any Question or Comment?

Leave a Reply

Your email address will not be published. Required fields are marked *

Copy Protected by Chetan's WP-Copyprotect.